Bottom of brace should be 26 1 2 673 mm up for floor.
American standard pedestal sink installation instructions.
Following manufacturer s instructions install faucet and drain assembly not included.
Stops 1 5 8 41mm to either side of center.
Cut out part of the wallboard to reveal the studs.
And extend a minimum of 12 305 mm to either side of.
Bolt pedestal to the floor.
Some pedestal sinks require a support board behind the finished wall for extra strength.
No responsibility is assumed for use of superseded or voided pages.
Sink and pedestal console installation 1.
Notch the studs for the support board with a jigsaw.
Connect the basin to the wall.
Install the mounting brace.
Dimensions of fixtures are nominal and may vary within the range of tolerances established by ansi standard a112 19 9.
Installation instructions supplied with lavatory.
Finished wall pedestal side section.
Check the manufacturer s instructions on your sink.
Attach the mounting bracket.
Two 2 x 8 50 x 203 mm wood braces to wall studs.
Space supplies hot cold screwdriver.
Remove excess putty after installing drain on sink.
Mark the sink height on the wall.